« previous next »
Pages: [1]   Go Down

Author Topic: Build an Alpina 4001  (Read 1420 times)

bridgetkeble

  • Newbie
  • *
  • Posts: 1
    • View Profile
Build an Alpina 4001
« on: August 21, 2024, 03:38:21 AM »
Hi Guys
I am building/finishing an old Alpina 4001 and need a bit of help on installing the wing mounting bracket in the fuzz.Any one on here done it before? This is the blade type with the brass box in the fuzz.The instructions i have limited on the install. EG i presume they Extend into the side of the fuzz.
Any help appreciated
Cheers.
Logged

Fred

  • Slope Soaring is not a crime!
  • Administrator
  • Newbie
  • *****
  • Posts: 5148
  • Gliderist Simplex
    • View Profile
    • http://www.gliderireland.net
Re: Build an Alpina 4001
« Reply #1 on: August 24, 2024, 12:16:23 PM »
Welcome to the forum :)

Back from holidays, but if your Alpina use the blade type, I don't think it's a 4001.
The 4001 use the floating keys if I recall.

Anyway, I can take photos of my old one, correct, they do extend to the fuselage wing root, at an angle (dihedral).
I post photos in a bit
Logged
Education is important, but flying RC planes and gliders is importanter!

Fred

  • Slope Soaring is not a crime!
  • Administrator
  • Newbie
  • *****
  • Posts: 5148
  • Gliderist Simplex
    • View Profile
    • http://www.gliderireland.net
Re: Build an Alpina 4001
« Reply #2 on: August 25, 2024, 22:14:17 PM »
Here are a couple from my old Alpina. Hope that helps.
Logged
Education is important, but flying RC planes and gliders is importanter!
Pages: [1]   Go Up
« previous next »