1
Slope Soaring / Re: Club hats, Wooley beanies
« on: November 17, 2019, 21:03:09 PM »
7 votes now 
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Club talk / Re: 2019 Fees
« on: March 10, 2019, 20:46:26 PM »
Hi Ralph,
If you could PM me the BIC and IBAN for a SEPA transfer please, I'll pay the club fee that.
All the best,
Zug
If you could PM me the BIC and IBAN for a SEPA transfer please, I'll pay the club fee that.
All the best,
Zug
3
How to... / Re: cutting rib notches in wing trailing edge
« on: October 26, 2017, 21:34:26 PM »
Thanks Bill.
The ribs are actually 3 mm wide. So I might try 3 blades taped together.
Zug
The ribs are actually 3 mm wide. So I might try 3 blades taped together.
Zug
4
How to... / cutting rib notches in wing trailing edge
« on: October 25, 2017, 14:11:03 PM »
Hi Guys,
I'm building my first model glider - an Echo Fox. The wing ribs on this model are notched into the wing trailing edge. Is there any recommended technique for cutting out the notches.
Do you just mark the notch out in pencil and then cut each side of it with a very fine saw and then chisel out the middle bit? The notches are small, but I'm guessing there is no special tool for doing it?
Many thanks,
Zug
I'm building my first model glider - an Echo Fox. The wing ribs on this model are notched into the wing trailing edge. Is there any recommended technique for cutting out the notches.
Do you just mark the notch out in pencil and then cut each side of it with a very fine saw and then chisel out the middle bit? The notches are small, but I'm guessing there is no special tool for doing it?
Many thanks,
Zug
Pages: [1]