« previous next »
Pages: [1]   Go Down

Author Topic: Coverings  (Read 4994 times)

stephen.shannon

  • Newbie
  • *
  • Posts: 163
    • View Profile
Coverings
« on: June 25, 2014, 23:13:52 PM »
I seem to be dominating this section of the forum ....  :shock:

Anyway, in the past six months I've stripped the covering off two planes that were ARTF kits ie not built up and covered. I've noticed that the cover on these 'factory' made/built models appear much thinner than the solarfilm or oracover I've used to recover the models.....


Is there an explanation for this? Are the covering processes vastly different?

Thanks

Stephen
Logged
Our deepest fear is not that we are weak but that we are powerful beyond measure..... Marianne Williamson

Fred

  • Slope Soaring is not a crime!
  • Administrator
  • Newbie
  • *****
  • Posts: 5149
  • Gliderist Simplex
    • View Profile
    • http://www.gliderireland.net
Coverings
« Reply #1 on: June 25, 2014, 23:33:38 PM »
Simple explanation: cost!
Cheaper material, a fraction of the cost of Oracover.
Logged
Education is important, but flying RC planes and gliders is importanter!

Happy Days

  • ISR Club Member
  • Newbie
  • *
  • Posts: 2184
    • View Profile
Re: Coverings
« Reply #2 on: June 26, 2014, 07:28:39 AM »
Quote from: "stephen.shannon"
I seem to be dominating this section of the forum ....  


Stephen’s misses was telling me the other day that he enjoys a bit of
‘Domination’ :shock:  (It’s all too kinky for me)

L. Keith
Logged
Try not to run out of airspeed, altitude and ideas....... all at the same time.
Pages: [1]   Go Up
« previous next »